Lesson 13

This lesson I did some soldering. Mr Andrews gave us a demonstration on how to use the soldering iron. What you have to do is wait for it to heat up and then on the very tip place the end of the wire from the ones we cut last week. Then a little bit of lead was put on the tip and it then melted onto the wire. This sealed the little wires together on the ends. I did this for every end of the wire. Later I went over to the wiring table and tried to figure out how to place the wires. I found this really difficult as there is so many wires. I connected one red wire. Then lastly I put a battery in to the holder so I could test if the wires were connected correctly. I will continue wiring next lesson as I ran out of time.